CIRCUIT DESIGN STD-302 Manual de usuario descargar pdf (Pagina 11)

OG_STD-302S-429M_v11e 11 Circuit Design, Inc.

OPERATION GUIDE

PLL IC CONTROL

 PLL IC control

OSCin

OSCout

VCC

GND

Xf in

Fin

STD-302

Control pin name

Data

2kohm

MB15E03SL

Reference Oscillator

LPF

Voltage Controled

Oscillator

VCO

PLL

CLK

DATA

LD/f out

+2.8v

#:Control v oltage = +2.8v

21.25MHz

up to 1200MHz

Figure 1

CLK

2kohm

STD-302S is equipped with an internal PLL frequency synthesizer as shown in Figure 1. The operation of the PLL

circuit enables the VCO to oscillate at a stable frequency. Transmission frequency is set externally by the

controlling IC. STD-302S has control terminals (CLK, LE, DATA) for the PLL IC and the setting data is sent to the

internal register serially via the data line. Also STD-302S has a Lock Detect (LD) terminal that shows the lock

status of the frequency. These signal lines are connected directly to the PLL IC through a 2 kΩ resistor.

The interface voltage of STD-302S is 2.8 V, so the control voltage must be the same.

STD-302S comes equipped with a Fujitsu MB15E03SL PLL IC. Please refer to the manual of the PLL IC.

The following is a supplementary description related to operation with STD-302S. In this description, the same

names and terminology as in the PLL IC manual are used, so please read the manual beforehand.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sin comentarios

CIRCUIT DESIGN STD-302 Manual de usuario Pagina 11